Simplify 3d not showing whole model8/9/2023 The reason I ask is because I've printed parts in the past with these parameters (in petg with a. 5mm layer height out on the part, and the part will measure 50mm tall? If so, then does the micro-stepping make selecting an integer value of. In other words, what really happens if I design a 50mm high part and I specify a. 0079 (assuming a constant step size in z)? For example instead of a 50 mm high part in z, I should design the part to be 49.77mm or 50.56mm high for best accuracy? 4977 instead? Does that also mean that if I design a part from scratch, that the overall design height should also be a multiple of. I think, after going back and reading this thread, that the step size should be some integer multiple of. I would say I print mostly with PETG or ABS then TPU's and co-polymers, then followed by the Nylons. It just doesn't hold any interest for what I would like to accomplish.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |